Blackout Comms Pager Firmware

Where are you located?
 If you are in the USA, choose the USA version. Otherwise, choose the Non-USA version. Use the same slection for all of your devices!

Note: The Blackout Comms secure off-grid messaging and location firmware is a licensed product. Certain features may require purchase of a license.

Blackout Comms for Lilygo Pager

This is not for Altware Pager! If you have that device, go to the Altware Pager Firmware Installer page.
  1. Recommended - SD cards are highly recommended but not required. Only compatible SD cards can be used.
  2. Connect the pager to your PC using a high quality data cable.
  3. The pager will automatically power on (if it's not already on).
  4. On the pager, hold the middle button, tap the reset button (left/first button), then release the middle button.
  5. Click the install button below and click through the steps.

By downloading this firmware, you are agreeing to the terms, agreeing to abide by all laws and regulations while using this firmware, and agreeing to hold harmless the developer, Altware Development LLC. Altware Development LLC is not responsible for any data loss or other issues that might arise with with your device before, during, or after flashing. Unless you agree to those terms, don't use this tool or download our firmware.

Alternative Flash Instructions: If you know what you are doing and want to install mesh tdeck firmware using a different install tool, you may download the pre-built binary here (USA): Pager